steelandstud.com
steelandstud.com
Insulation is a must-have if you want comfort and energy-saving and will also help maintain temperature, reduce moisture, and absorb sound.
The main aim of insulation is to cover all walls, roofs, seams, and joints to reduce dampness, moisture, or condensation.
steelandstud.com
steelandstud.com
steelandstud.com
steelandstud.com
While on average, insulation will cost you from $1.5 to $4.5 per square foot.
steelandstud.com
There are mainly two methods in use for installing insulation.
First one is corner to corner method
Second option is wrap-around method
in this method, you can start doing the side walls first, beginning in one corner till the other corner, then doing the roof, and finally finish with the end walls, and gable ends.
you will need to go all the way down to one wall, make a 90-degree turn, and then continue going down on another wall until you have finished all the walls
steelandstud.com
STEP 1-A The Walls
STEP 1-B The Corners
You need to use the floor of the building and the bottom part of the frame as your guide to starting the first run
Install the radiant barrier foil in such a way that the foil side is facing out of the building.
You should have 4-5″ left on the end when you reach the corners.
It’s essential to use a flat blade like a dry blade or putty knife at corners for pushing the insulation deep into the corners, as corners are often the weak points in any insulation installation process.
steelandstud.com
STEP 2-A The Second Run
STEP 2-B Prepping the Corner Bracing
You will need to line up the insulation with the sharpie mark that you made at 92″ while marking up the metal frame.
You can use the tape for lining up the insulation sheet with the tape edge pointing towards the bottom.
You will need to remove the two bottom screws of the brace (corner spacing is depicted using the red line in the first illustration).
Now pull the bracing away from the wall at least 2″-4″. Run the insulation behind the corner brace around the wall, and fasten it to the wall using the screws or fasteners.
steelandstud.com
STEP 3-The Roofline
STEP 4-Finish Up
You must try to keep a continuous new interior surface by connecting the walls to the bottom of the roofline
Now, the final step is to finish the insulation process by taping all the seams and gaps in the insulation.
steelandstud.com